User's Manual
Table Of Contents
- Safety and Precautions
- Contents
- Supported Devices
- Unpack
- Scanner Parts
- LED Messages
- Insert AAA Batteries
- Set the Resolution
- Set the Scanner Mode
- Install the iScanAir Go app (Wi-Fi Mode)
- Connect to Wireless Network (Wi-Fi Mode)
- Scan, Save, and Share (Wi-Fi Mode)
- Use as the Standalone Scanner (MicroSD Mode)
- Clean Lens and Rollers
- Calibrate
- Helpful Hints
- Specifications
18
Calibrate
Calibrate in the MicroSD Mode
1. Slide the Wi-Fi/Micro SD switch to “MicroSD”.
2. Press and hold the POWER/SCAN button for 10
seconds until the Wi-Fi LED blinks a purple light.
3.
Remove the plastic foil on the Calibration Sheet,
place it on the table with the white side facing up.
4. Place the scanner on the Calibration Sheet, then
move it back and forth only in the white area few
times until the Scanner turns off.