User's Manual
Table Of Contents
- Safety and Precautions
- Contents
- Supported Devices
- Unpack
- Scanner Parts
- LED Messages
- Insert AAA Batteries
- Set the Resolution
- Set the Scanner Mode
- Install the iScanAir Go app (Wi-Fi Mode)
- Connect to Wireless Network (Wi-Fi Mode)
- Scan, Save, and Share (Wi-Fi Mode)
- Use as the Standalone Scanner (MicroSD Mode)
- Clean Lens and Rollers
- Calibrate
- Helpful Hints
- Specifications
15
Use as the Standalone Scanner (MicroSD Mode)
•
Ensure the Scanner is switched to the “MicroSD” mode on
the side of the Scanner. (See p.10)
NOTES
1. Insert a microSD card into the card slot with the
gold contacts facing up.
2. Place the Scanner on the object with the scanning
lens facing down, making sure the scanned area is
located between the two arrows on the scanner.
3. Press the POWER/SCAN button to start scanning,
and
move the scanner slowly and steadily down
towards the bottom of the object.
* Ensure the Status LED blink green light at the normal speed.
4. Press the
POWER/SCAN
button again to end
scanning and save the image to the microSD card.
* The Power LED will blink orange light.
Browse and Transfer Images
Connect computer and the Scanner with the microSD
card inside using the USB Cable. Turn on the Scanner.
You can browse the Scanner as a portable hard disk,
then transfer/copy scanned images to your computer.
* No battery is required if the Scanner is used as a portable hard disk.
ON
Press POWER/SCAN to end.
Press POWER/SCAN to start.