User's Manual
Table Of Contents
- Safety and Precautions
- Contents
- Supported Devices
- Unpack
- Scanner Parts
- LED Messages
- Insert AAA Batteries
- Set the Resolution
- Set the Scanner Mode
- Install the iScanAir Go app (Wi-Fi Mode)
- Connect to Wireless Network (Wi-Fi Mode)
- Scan, Save, and Share (Wi-Fi Mode)
- Use as the Standalone Scanner (MicroSD Mode)
- Clean Lens and Rollers
- Calibrate
- Helpful Hints
- Specifications
12
Connect to Wireless Network (Wi-Fi Mode)
You can make a direct wireless connection between the
Scanner and your device in following steps.
1. Press and hold the POWER/SCAN button for 3
seconds until the power LED emits green light.
* Wait about 20 seconds until the Wi-Fi LED blinks blue light.
2. Enable the Wi-Fi mode on your device, search
the “DIRECT-xxxxxx_iScanAirGo” network for the
Scanner, then select it.
* The "xxxxxx" in the network name is a 6-digit code randomly
assigned for your Scanner.
3. Input 8-digit password “
12345678
” to connect
the Scanner.
* The Wi-Fi indicator will stop blinking and become a solid
blue light after connected.
ConnectedWi-Fi On
•
Be sure the Scanner is used within approximately 60 feet
~100 feet (18m~30m) from your Wi-Fi enabled device in
an obstacle free indoor environment.
• The Scanner will automatically shut down if there is no
operation for 5 minutes for saving power.
•
The Scanner allows connection up to 8 Wi-Fi enabled
devices at once.
NOTES
ON