Installation Guide

Close top flaps and turn carton upside down and open bottom flaps. Tub cover (1) is beneath cardboard
along side panel and should be removed through opening of base. Leave bottom flaps open and turn tub
right side up. Remove corner pieces and lift carton from tub.
SPECIFICATIONS
UNPACKING:
Refer to the faucet owners manual for installing and
connecting the faucet. If the cabinet will be placed flush
against the wall use flexible supply pipes or galvanized pipe.
There will not be enough space to solder copper piping
without damaging the tub or cabinet.
Mount the faucet on the tub deck. Bring the supply lines from
the faucet through the hole on the side (either right or left) of
the cabinet. Move the cabinet into position and complete the
faucet connection.
Level the base before tightening. (See Fig. 1)
Complete the installation by connecting drain.
INSTALLATION:
MODEL NO. 91
CABINET STYLE • SINGLE LAUNDRY TUB
Do not subject tub or cabinet to direct torch flame while making plumbing
connections. Check local plumbing codes for faucet and drain connections.
CAUTION
FIG. 1
SI-74 (02•15)