MODEL NO.
IMPORTANT INSTRUCTIONS 1. Read all instructions before using this heater. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least three feet (0.9m) from the front of the heater and keep them away from the sides and rear. 3.
and cause a risk of fire. 16. This heater may include an audible (a visual) alarm to warm that parts of the heater are getting excessively hot, if the alarm sounds (flashes), immediately turn the heater off and inspect for any objects on or adjacent to the heater that may cause high temperatures. DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING (FLASHING) 17. SAVE THESE INSTRUCTIONS How to operate: Special characteristics of this heater a.
Unpacking and installing the appliance Open the packaging carefully and remove the appliance. Keep the original packaging for future transport. Keep the front of the appliance through which the heat is radiated at least one meter away from furniture, curtains and other flammable objects at all times. Ensure there is a grounded socket nearby. ( back of the appliance). Never use an extension lead. The mains cable must remain at the back of the appliance and must not be in contact with any hot elements.
cannot be used for any other purpose. Any damage due to inappropriate operation, wrongful use or not observing the safety instructions is not covered by the guarantee. Please operate the heater after inserting it into the mantle. Never operate the appliance when the appliance itself or the mains cable show any signs of damage. Be responsible when handling the packing material. Warning: plastic wrapping may be lethal to children. Do not place the appliance below a socket.
Instructions for the approved electrotechnician The appliance comes with the following light bulbs: two 40W light bulbs(max. 40W) Changing the bulbs Warning: unplug first! The plug must be removed from the socket-outlet before changing 1. open the front access panel 2.
3. change the bulbs CAUTION: sharp edges! You can now replace faulty bulbs by identical ones with the same wattage. For assembly, proceed in reverse order. 1. After installation, the power plug should be accessible. 2. if the power cord is damaged. It must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. 3. the heater must be located immediately below a socket. 4. the appliance is not intended for use by young children or infirm persons.
Grounding instructions This heater is for use on 120 volts. The cord has a plug as shown in Figure A. Figure A Technical data: Mains voltage: 120V Mains frequency: 60Hz Nominal charge: max.
第 9 页
