Instructions / Assembly

GET READY TO START
Beforeassembly,usescissorstounwrapthepartsfromthepackaging.DO
NOTuseaboxcutterorexacto-knifeasyoumaycutintothemantelpieces
insidetheboxanddamagethenish.Checkforthehardwarebagwhichisred
andlocatedinsidethepackaging,tapedtothetopbox.BesureyouDONOT
discardanypieces.
Step 1
Locatethebaseandplaceitontheoor.Do
notputitupagainstthewallatthispointinthe
assembly,asyouneedtogetinbehindthemantel
toinsertseveralwingnuts,lockwashersand
reboxscrews.
Step 2
Locatetheleftsidepanelandtheleftfrontpanel.Facingthefrontofthebase,
taketheleftsidepanel,positioningitsotheholesintheblocksonthebottom
lineupwiththeholesonthebase.Positiontheleftfrontpanelnexttotheleft
sidepanel,lininguptheholesintheblockswiththeholesonthebase.Attach
theleftfrontandsidepaneltothebasebyinsertingandtightening1wingnut
and1lockwashertoeachblock.Attachtheleftsideandfrontpanelstogether
byinsertingandtightening3wingnutsand3lockwashers.
Step 3
RepeatStep2,butwiththerightsidepanelandtherightfrontpanel.
Step 4
Locatethecentralheaderthatwillbeattachedtotheleftandrightlegs.
Positionthispanelwiththenishedsidefacingthefrontofthemantel.Lineup
theholesoneachsideandinsertandtighten2wingnutsand2lockwashers
oneachside.
Step 5
Locatetheupperfacingpanelthatwillbeattachedtotheleftandrightlegs
andwillsitabovetherebox.Lineuptheholesoneachsideandinsertand
tighten1wingnutand1lockwasheroneachside.
2
Step 2 & 3
Step 4
Step 5
Step 1