Warranty

12
USING THE THERMOSTAT CONTROL BUTTON
□ Pressing the heat button (3) once turns the heater fan
on.
□ Press and hold the heater button for 5 seconds to
enter the temperature mode. After 5 seconds press
the heat button to cycle through the different heat
settings. Continue to press the heat button to cycle
through the different heat settings.
□ Once the desired room temperature is reached the
heater fan will deactivate.
□ Reference the table for more information.
□ To display the temperature setting in either Fahrenheit
or Celsius, press the heat button (3) of control panel
once, then press and hold the power button (1) of
control panel for 5 seconds. The display will beep and
switch between Fahrenheit or Celsius.
Operation (continued)
NOTE: If this product experiences exceptionally
high temperature, it may automatically stop heating.
If this occurs the product should be unplugged
or isolated from the main supply for a period of 5
minutes before the power is then resupplied.
Button Press Timer Interval Display Value
1st Press 30 Min 30
2nd Press 1 Hour 1H
3rd Press 2 Hours 2H
4th Press 3 Hours 3H
5th Press 4 Hours 4H
6th Press 5 Hours 5H
7th Press 6 Hours 6H
Button
Press
Celsius
Temperature
1 17°C
2 18°C
3 19°C
4 20°C
5 21°C
6 22°C
7 23°C
8 24°C
9 25°C
10 26°C
11 27°C
12 ON
Button
Press
Fahrenheit
Temperature
1 62°F
2 63°F
3 64°F
4 65°F
5 66°F
6 67°F
7 68°F
8 69°F
9 70°F
10 71°F
11 72°F
12 73°F
13 74°F
14 75°F
15 76°F
16 77°F
17 78°F
18 79°F
19 80°F
20 81°F
21 82°F
22 ON
USING THE TIMER CONTROL BUTTON
□ Pressing the timer control button (4) will set the timer. This
interval period is shown in the display (8) on the control
panel on the side of the electric fireplace. The set intervals
are as listed in the table.