User manual

EFX MkIII Audio Controller User Manual 11
Cable Wiring for External Foot Switch
The cable required is a mono (TS) to a mono(TS) 1/4" phone plugs.
Note
*Thenot. means no Control Change is transmitted.
* The last decimal point on the display means that the display shows a Program Change number or controller
number.
* For initial default Control Change channels and controller numbers setting are refer to page 12.
* Connect a expression pedal or a external foot switch to the XPDL jack before the power applies to EFX
MkIII Audio Controller.
3.3.4 Popping Noise Reduction Control
Ths EFX MkIII Audio Controller is based on relay switching. This method is utilized to route the audio signal
with absolutely no tone coloration or degradation. But the disadvantage of relays is that they can produce a
slight popping noise when they switch on/off. The 10-stage popping noise reduction cont rol is excellent for
reducing this popping noise by muting time control of audio signal and switching order when the relays switch
on/off.
* The popping noise reduction control is global (the same for all banks/presets). you need not edit this for
any other banks/presets if you have already done so.
Press/hold the① PS-1 switch(FS, function select) to set the popping noise reduction
control until the Pr.0 is shown on the display if you are already in the Edit Mode.
Press/hold the② BANK UP switch to set a popping noise r eduction control f rom
Pr.0 through Pr.9.
It will automatically be stored in memory when you return to Preset Mode.
Pr0 means the popping noise reduction contr ol is not used.
⋮
Pr9 means the maximum of the popping noise reduction control.
Note
* The initial default setting is Pr.0.