User manual

EFX MkIII Audio Controller User Manual 10
or a plug is not connected to the XPDL jack.
Press the② PS-2 switch(CH, channel) to set a EPL or ESW channel. The display
will show the EPL or ESW channel.
Press/hold the③ BANK UP or BANK DOWN switches to select a channel from 1
through 16.
Press the④ PS-2 switch to store a new channel in memory. The display will show
str (store) for a moment.
Press the⑤ PS-3 switch(NUM, number) to set a EPL or ESW controller number.
The display will show the current EPL or ESW controller number.
Press/hold the⑥ BANK UP or BANK DOWN switches to select a EPL or ESW
controller number from 000. through 127. or not..
Press the⑦ PS-3 switch to store a new EPL or ESW controller number in memory.
The display will show str (store) for a moment.
The EFX MkIII has an additional reverse function which reverse the control value.⑧
Press the PS-4 switch(TGL, toggle) to reverse a EPL or ESW control value. The
display will show the current EPL or ESW control value mode.
The table below shows the control value of the normal and reverse mode.
Expression Pedal (EPL) External Foot switch (ESW)
Normal Reverse Normal Reverse
Minimum Position 0(0x00)
127 (0x7F) Open 0 (0x00) 127 (0x7F)
⋮ ⋮
⋮ Closed 127 (0x7F) 0 (0x 00)
Maxnimum Position 127 (0x7F)
0(0x00)
Press the⑨ BANK UP switch to toggle between normal and reverse. The display
will show:
Press the⑩ PS-4 switch to store the reverse function in memory. The display will
show str(store) for a moment.
Cable Wiri ng for Expression Pedal
The cable required is a stereo (TRS) to two mono 1/4" phone plugs. Connect the tip(stereo plug) to the pedal
input, ring to the pedal output and sleeve to ground on all 3 plugs.