Specifications

RoadRunner USERS GUIDE

If you have been given only one SPID

number, enter this number for the first ‘B’

channel only.

5ESS, Custom: If you service provider says you have

‘Custom ISDN’, you can have ‘point-to-

point’ or ‘point-to-multipoint’. In either

case, set the switch type to 5ESS Custom.

5ESS, National or Custom, version 5E9.1: 1 + area code + phone

number dialing is required for all calls,

including local.

DMS-100, National ISDN: SPID numbers are always used and begin

with the area code + 7 digit number. The

SPID number may end with ‘00’, ‘01’, ‘0100’

or other suffix. Enter the SPID number as

provided by your service provider, do not

put a ‘1’ in front of the SPID number. Select

NI1 as the switch type.

In any of the above cases, if SPID numbers are used, ID numbers are

also used. You must use a seven-digit ID number when using a

TA201/TA301.

Very early versions of the TA201/301 did not support 56 kb/s

operation. MUSICAM USA will be happy to upgrade any of these early

units if you require 56 kb/s connectivity.

Control Problems

Symptom Possible cause Solution

Keypad not

responding

1. Reset to factory defaults

Not responding to

remote terminal

control

—Improper cable.

—Incorrect port setting.

—Incorrect protocol mode.

1. Use standard RS232 cable

1. Check settings match terminal

or computer.

1. Insure RS232 protocol is ‘OFF’

for terminal control, ‘ON’ for

program control.

“Arguments Bad” —Incorrect number of 1. Check command syntax