Specifications

X-CAN
V8
AMPLIFIER OPERATION
Issue 1
Page 7 of 11
STARTING
Once all connections are made, the power LED on the
front panel will light, indicating unit is ready for use.
VOLUME
The volume control knob should be adjusted for normal
listening levels.
LINE IN
To use the line input connect desired source to line in
RCA sockets. To listen to music from the line input,
move the front panel switch to the down position.
USB INPUT
To use the USB input connect computer to USB input
socket. To listen to music from the USB input, move
the front panel switch to the up position
LINE OUT
The line output RCA sockets are included to facilitate
connection of the XCAN V8 into an existing system. To
take advantage of this, the XCAN V8 can be connected
to the tape output (or similar) of any pre- or integrated
amplifier. Any device that was plugged into the tape
output should now be plugged into the line output RCA
sockets on the X-CAN V8 which will reinstate the
original connection, the X-CAN V8 passing on the
signal for recording or other purposes. These outputs are
not affected by the XCAN V8 volume control.
HEADPHONES
Up to two pairs of headphones can be connected to the
unit through the front panel jack sockets.
Both sets will then be simultaneously controlled by the
volume control.
Note: Two different headphones thus connected may
produce differing output levels and/or musical tones.
This is normal and due to design of the respective
headphones.