Specifications

X-CAN
V8
INSTALLATION
Issue 1
Page 5 of 11
INTRODUCTION
Congratulations on the purchase of the new X-CAN V8
integrated valve headphone amp. Great attention has been paid
to internal layout, isolating each circuit section to prevent
possible interaction.
The unit features our highly refined ECC88 dual triode valve
input amplifier circuit coupled with a new low output
impedance driver stage to improve current delivery and
dynamics to lower impedance headphones. Twin jack sockets
are provided so it is possible to share the musical experience!
A USB input is also provided for listening to computer-based
music collections. This interfaces easily with most PC/MAC
computers without additional drivers.
The resultant performance achieved by this unit is among the
best in the world. It has excellent signal to noise ratio, low
distortion, wide bandwidth, huge dynamic range,
extraordinary resolution and fine detail.
CLEANING
Before cleaning the unit, switch off power at the mains switch
and remove the mains plug from the wall socket.
Clean the cabinet and remote control unit using a moist cloth.
Using solvents, white spirit or thinners is not advised, as they
could damage the surface finish.
INSTALLATION
Position the X-CAN V8 on a stable, horizontal surface where
there is no risk of it being knocked, or subjected to vibration
such as from loudspeakers.
The X-CAN V8 must be protected from humidity - if the unit
is moved from a cold place to a warm room, leave the unit for
an hour or so to allow sufficient time for the moisture to
evaporate.
POWER CONNECTIONS
The X-CAN V8 requires a free mains socket for its power
supply. The power supply then connects using its flying lead
to the DIN 24V AC socket at the back of the unit. We advise
that you use only the supplied X-series adaptor for this unit,
or a Musical Fidelity power supply.
AUDIO CONNECTIONS
Inputs: Connect analogue input to RCA line inputs
(see p.7 For more information). Use good quality fully
connected (signal and ground) coaxial phono cables for all
signal connections.
Outputs: Connect one or two sets of headphones to the
output sockets
The LOOP outputs allow direct pass-through of the input
signals to tape/MD/CD recorder, for example. They are
directly connected to the line inputs and are not affected by
the volume control on the XCAN V8