MODEL :G-GO USER’S Guide 1
Contents A. Package contents B. Important Safety Instructions C. Your G-GO D. Power Up E. Get Connected F. Get Listening G. USB Universal Charging H. Trouble Shooting I.
A. Package contents Your G-Go comes with the items shown below. l AC adaptor l User’s guide and Quick start guide B. Important Safety Instruction CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Section 15.105 Information to the user. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
C.
LED status Indicator White Lit Blue Lit LED Status Speaker Status Steady Power On Flashes Battery is low; Pause music when playback Steady Connected to Bluetooth device Flashes Pair mode Splash Proof G-Go is splash proof, which is suitable for outdoor use. D. Power Up AC Connection or Battery installation 1. Insert the supplied AC adaptor (DC 9V 1.8A) to DC IN. Connect the other end to a wall outlet. Or, For portable use, insert four “AA” size batteries in the battery compartment 2.
E. Get connected Wireless stream audio from any Bluetooth device (Phone, Computer, etc.) via Bluetooth 1. Prepare your G-Go for pairing i. Press Bluetooth button and blue LED flashes ii. Blue LED flashes in pair mode iii. Blue LED lit up steady when connected Noted: Press and hold Bluetooth button for 3 seconds to disconnect the Bluetooth connection. G-Go then go back to pair mode and blue LED flashes. 2. Prepare your phone or device for pairing i. Turn on Bluetooth feature on your Bluetooth device ii.
ELECTRI C SHOCK DO NOT OPEN EQ There are 4 preset EQ settings. EQ1 = Flat, EQ2=Rock, EQ3=Pop, EQ4=Jazz. Press EQ button to cycle through the following options: EQ1, EQ2, EQ3 and EQ4. White LED flash 1, 2, 3 or 4 times when EQ button pressed to indicate if on preset EQ1, 2, 3 or 4. Note: Default setting is EQ1 (Flat). Forward or Reverse Press forward or reverse buttons to skip to the beginning of the current/previous or next track. G.
