PATEL Ten ALT rs / at ant THE J. LZ 14 CHANNEL FAMILY RADIO SYSTEM F RS-89A BEFORE OPERATING THIS PRODUCT PLEASE READ THESE INSTRUCTIONS COMPLETELY M7 pat 91an02 965 al? SD, CONTENTS 09 JAN 2002 Safety Information. FCC Warnings Precaution Features Controls and Indicators . LCD Display To Install Batteries To Recharge Batteries .. To Turn On or Turn Off The Unit. Auto Battery Power Saver, To Transmit To Adjust Vol To Select Channel Automatic Channel Scan Monitor button...
Safety Information Your wireless hand-held portable transceiver contains a low power transmitter. When the Push-to-Talk (PTT) button is pushed it sends out radio frequency (RIF) signals. The device is authorized to operate at a duty factor not te exceed 50%. In August 1996, the Federal Communications Commissions (FCC} adopted RF exposure guidelines with safety levels for hand-held wireless devices.
Controls and Indicators 9. PPM pL . Belt Clip Antenna Battery Saver Power switch Up/Down key PTT (Push To 10. Menu key 1 1. Call key 12. Microphone 13. Speaker LCD Display “tp Transmit \yf2/ (Talk) Indicator AY Receive (Listen) Indicator Level — Indicator t BJan0Z p65 . Enter/Lock key .
To Turn On The Unit or To Turn Off The Unit Press the POWER switch for mots than 1 second. Auto Battery Power Saver The unit has a special circuit designed to extend battery life. If there are no transmissions within 5 seconds, the unit will automatically switch to battery save mode. To Transmit Press the button and simply talk to the built-in microphone. Many times the limits to maximum possible range are environmental factors such as blockage caused by trees, buildings, hills, or other obstructions.
To Set Dual Watch Function This feature enables you to monster 2 channels simultaneously. Set Main and Sub channels you want to monitor prior to set Dual Watch Function. 1. Press the MENU button repeatedly until the LCD display indicates as shown at right. *F” indicates Taut Watch set off. 2. Press the LIP or DOWN button to seat desired channel to monitor. Example: Ch? 3. Press the MENU button to continue other settings. To complete setting, press the ENTER button.
[ To Turn On or Off Roger Tone (Talk Confirmation Tone) This alerts the other party that you are finished talking and it's OK General Specifications A. Frequency CH = 14 Channels within 462.5625 MHz -467.7125 MHz. for them to begin talking. 1. Press the MENU button repeatedly until B. Receiver the LCD display indicates as shown at 1. Sensitivity i SE ind . ivi right. “F” indicates Roger Tone set Off. For 12 dB signal 0.25 wv 2. Max. audio output @ 10% THD 300 mW 2. Press the UP or DOWN button to turn 3.
