User guide

www.jbl.com
CALIBRATION/SETUP
Rear speakers
1. The MS-8 will then display Rear, with the options None and 1 way. (Separate outputs
for two-way speakers are not available for side or rear speakers.)
2. Use the remote’s Up and Down navigation buttons to highlight one of these options,
and press the Select button to select it. NOTE: If you are using only one set of
speakers in the back of the car or if there are no speakers in the back of the car, select
None.
3. The MS-8 will then display Rear Hi Pass. This screen enables you to choose the
high-pass lter for the rear speakers. Use the remote’s Left and Right navigation
buttons to display a frequency between 50Hz and 10kHz, and press the Select button
to select it. We recommend using at least 100Hz.
4. The MS-8 will then display Rear Hi Pass Slope. This screen enables you to choose the
lter’s attenuation rate. Use the Up and Down navigation buttons to highlight a slope,
and press the Select button to select it. We recommend using 24dB/octave.
The MS-8 will then display the Xover Setup menu, which lists all the speakers you have
set up. If you need to make corrections, select the appropriate speaker location from the
menu, and reenter the information as well as all of the information for the speakers that
follow. When you are nished with all of the output-setup settings, select Done.
Channel selection
The MS-8 will then display the Channel Selection menu. This menu enables you to
assign the outputs that you congured in all the Xover Setup menus to specic output
channels, by number. This menu will display only valid choices (according to your entries
in the Xover Setup menus). Select the output channel based on the connections that you
documented in the Conguration Chart you lled out on page 11, in the audio outputs
section:
1. If a speaker or amplier is connected to the MS-8’s Channel 1, select Channel 1 from
the Channel Selection menu.
2. The MS-8 will display the Channel 1 menu, which will list the available choices based
on the entries that you made in Xover Setup. The following choices may be available:
FL – Front left (full-range speaker)
FL Hi – Front left tweeter (or midrange/tweeter combination with passive crossover)
FL Mid – Front left midrange
FL Lo – Front left low (woofer, midbass or midrange)
FR – Front right (full-range speaker)
FR Hi – Front right tweeter (or midrange/tweeter combination with passive crossover)
FR Mid – Front right midrange
FR Lo –Front right low (woofer, midbass or midrange)
Sub 1 – Subwoofer 1
Sub 2 – Subwoofer 2
Ctr – Center (full-range)
Ctr Hi – Center tweeter
Ctr Lo – Center low (woofer or midrange)
SL – Side left
SR – Side right
RL – Rear left
RR – Rear right
31