User guide

www.jbl.com
INSTALLATION
To install the display unit with mounting screws
1. Place the mounting plate at the installation site and rotate it so that its arrow will point toward
the hex set screw at the back of the base after it’s installed.
2. Holding the mounting plate in position, fasten it to the surface with three enclosed mounting
screws.
3. Place the display unit on the mounting plate (180° from its nal position). Rotate it a half-turn to
the nal position. Tighten the hex set screw at the back of the base.
4. Connect the supplied cable to the display unit. If you haven’t already done so, route the cable
to the main unit and plug it into the main unit’s display connector.
Mounting with screwsMounting with adhesive
Set
screw
Set
screw
a) Insert the mounting plate, rotate it 180°, and tighten the hex set screw as shown below.
b) Wipe the installation-site surface and the exposed mounting plate with one of the enclosed
alcohol pads. Allow both to dry.
c) Remove the protective tape from one side of one of the enclosed adhesive pads, and
press the pad against the mounting plate.
d) Remove the remaining protective tape, and press and hold the display unit to its site
for ve seconds.
20