Technical data

LU940407

6. Mai 1992 @ 12:49 Uhr

1 Front of the MS-8

123 65

1 Front of the MS-8

(1) The LC-DISPLAY

To communicate with the MS-8 please follow the instructions of the LC-DISPLAY (1).

The data in each menu shows data which can be changed by pressing one of the

CURSOR keys (2) [ ], [ ][ ] and [ ], or the functionkeys (F1 - F4) (5). The viewing

angle of the LC-DISPLAY is adjustable, by using the DISPLAY CONTRAST control

(16), located on the rear. This is very helpful if the MS-8 is mounted high in a rack or

low on a small amp.

(2) The CURSOR keys

With the CURSOR keys [ ] and [ ] you can select the functions or parameters of

the MS-8, and with the CURSOR keys [ ] and [ ] you can change the values of

those parameters.

(3) The "STORE" key

With this key you can store or copy programs. In some menus the "STORE" key is

used for special functions, to make handling easier. (see corresponding chapters)

(4) The "EXIT" key

With this key you can interupt a store or copy function without changing anything. With

the CURSOR keys (2) you select a menu ("Go into" a menu) and with the "EXIT" key

(4) you leave it ("Go out" of a menu).

(5) The FUNCTION keys (F1 - F4)

These four keys have the same functions as the connected FOOTSWITCHES (F1-F4)

(13) at the rear of the MS-8. (If the MS-8 is in the "PLAY") In some menus these keys are

used for special functions, to make handling easier. (see corresponding chapters)

(6) The LED-lamps above key "SWITCHES 1 - 8"

show whether a connected unit is activated or is not activated. In non activated state the

LEDS are dimmed so that you still can see them in the dark. Flashing of one LED indicates

special functions. (see corresponding chapters)

(7) The key "SWITCHES 1 - 8"

These keys control the switches / relays. Also you can select special functions for these

keys in some menus.

2 Rear of the MS-8

(8) The ON / OFF SWITCH

This key switches the MS-8 ON and OFF.

(9) The AC-IN jack

Connect the power supply unit (PSU) to this jack. You can use either a PSU with AC 7.5V

/ 1A or DC 10V / 1.2 A.

WARNING: Other PSU may not work properly or could damage the MS-8.