Use and Care Manual

CRUZ ZERO TURN MOWER CRUZ ZERO TURN MOWER

3736

Fig. 25C

Fig. 25B

Changing the Deck Belt

1. Remove the deck. Refer to the “Removing the Cutting

Deck” section.

2. Remove the two belt protective covers (a, Fig. 26) by

removing the six screws that fasten them to the deck.

3. Remove the ﬁxed pulley (b, Fig.26) and tension pulley

(c, Fig.26).

4. Carefully remove the deck belt from around the pulleys.

5. Reverse the process to reattach a new deck belt to the

deck.

Fig. 26

WARNING:

Belts on your mower are subject to wear

and should be replaced if any signs of wear are present.

WARNING:

Stop the engine, engage the parking

brake, and remove the key.

Changing the Drive Belt

1. Remove the deck. Refer to the “Removing the Cutting

Deck” section.

2. Remove the tension spring (a, Fig. 27A).

3. Remove the tension wheel (b, Fig. 27A).

4. Unplug the electromagnetic clutch harness from its

connector (c, Fig. 27B).

5. Remove the mounting bracket from the electromagnetic

clutch (d, Fig. 27A).

6. Remove the drive belt.

7. Reverse the process to reattach a new drive belt to the

mower.

Fig. 27A

Fig. 27B

WARNING:

To change the drive belt, it is recommended

to raise the mower by either placing it on a lift or by using

a jack and jack stands.Make sure the mower is properly

secured and the parking brake is set before proceeding.

Failure to properly secure the mower could cause it to fall,

resulting in death or serious injury.

WARNING:

Stop the engine, engage the parking

brake, and remove the key.