Operating instructions

ASSEMBLY
4.
HOW TO INSTALL THE MOWER HOUSING
Use the fasteners shown below to install the mower housing. The
fasteners are shown at full size.
1. Move the blade rotation con-
trol to the DISENGAGE posi-
tion (Figure 5).
2. Move the lift lever to the level
adjustment position (Figure 4).
WARNING: The lift lever
is spring loaded. Make
sure the lift lever islocked
in the LEVEL ADJUST-
MENT position.
3. Push the mower housing under
the right side of the unit.
Putthe mower drive belt aroundthe stack pulley. See Illustra-
tion "G" Figure 5. Make sure the _ side of the mower drive
belt is against the stack pulley. Also, make sure the mower
drive belt is not twisted.
5. Attach the front hanger to the axle support with the hanger
rod. Fasten with the fasteners as shown. See illustration=F".
6. Make sure the mower drive belt is between the stack pulley
and the two belt guides. See illustration"G".
7. Attach the suspension links to the lifter assembly. Fasten
with the washers (B) and hair pins (A). See illustrations=A"and
=B'.
8. Attach the rightand the left adjuster arms to the suspension
brackets. Fasten with the washers (13)and hair pins (A). See
illustrations =C"and "D'.
9. Attach the extension spring to the blade control rod. See
illustration "E".
10. Move the blade rotation control to the ENGAGE position.
Make sure the mower drive belt is inside all the belt guides.
11. Make sure the mower housing is level. See the instructions on
"How To Level The Mower Housing'.
12. Check the operation ofthe blade rotation control. See the in-
structions on "How To Adjust The Blade Rotation Control".
A
B
B
B
Adjuster SuS_.nr_Sion
Lifter
Assembly
LiftLever
\
Blade Rotation
Con_-ol
MowerDriveBelt
'C Mower Drive Belt .)
C B
Extension
Spring Blade
FrontHanger
HangerRod
F
Figure5
F- 98893 11