Operating instructions

ASSEMBLY
HOW TO INSTALL THE SEAT
Use the fasteners shown below to installthe seat. The fasteners are
shown at full size.
3.
Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts. Slide the seat forward
orbackward along the seat adjusting holes as shown. Tighten
the wing bolts (A).
1.
2.
©
(A) (a)
94160 17x47Z
Carefully remove the plastic bag from the seat.
Align the holes in the seat hinge to the holes in the seat
(Figure 1). Fasten the seat to the seat hinge withthe fasteners
as shown.
SeatHinge
Seat
AdjusSngHole
,A
HOW TO ASSEMBLE THE STEERING WHEEL
Fasteners are not required to assemble the steering wheel. Attach
the steering wheel as follows:
1. Make sure the front wheels pointforward.
2. Look at the hub ofthe steering wheel. Make sure the locking
clip is in place inside the hub.
3. Slide the cover over the steering post (Figure 2).
4. Slide the steering wheel onto the steering post. Push on the
steering wheel. The steering wheel will lock onto the steering
post. Pull on the steering wheel. Make sure the steering wheel
is locked in place.
5. Some models have an optional decal in the parts bag. Attach
the decal to the center of the steering wheel as shown.
Hub
Cover
HOW TO ASSEMBLE THE GAUGE WHEELS
Use the fasteners shown below to install the gauge wheels. The
fasteners are shown at full size.
1. Attach the gauge wheels to the axle bolts with the fasteners.
NOTE: The axle bolt is mounted inthe LOW position. To change
the position to a higher cutting position, see "How To Adjust
The Gauge Wheels" in the Maintenance section.
F- 98893
10
Gauge Wheel
Figure 3