Operating instructions

TROUBLE SHOOTING CHART
The Engine will not start.
1. Move the throttle control lever to the FAST or START poaition.
2. Make sure the fuel tank is filled with clean gasoline. Do not use old gasoline.
3. On a cold engine, push the primer button (optionol on some modals) five timas.
4. Make sure the wire for the spark plug is connected to the spark plug.
5. Adjustthe Carburetor. See the "Engine tnstruc_on Book'.
6. There is too much gasoline in the engine cylinder. Remove and dry the spark plug. Put the
throttle control in the SLOW position. Pull the recoil- start grip several times. Install the spark
plug. Connect the wire to the spark plug. Start the engine.
7. The engine is dltfificultto start in heavy or high grass. Move the mower to a clean dry surface.
8. Make sure the engine stop lever is in the operating position.
g. Make sure the fuel valve is inthe ON position. See the "Engine Instruction Book'.
10. On eleotric start models, make sure the wiring harn_s is connected. Charge the battery.
The Engine will not stop.
1. Release the engine stop lever.
2. Check the engine stop cable. Replace the cable if bent or damaged.
The Engine performance is bad.
1. Check the height of cut settings. Raise the height of cut if the grass is high.
2. Check the bottom of the blade housing. Clean the blade housing of grass and other debris.
3. Check the wire to the spark plug. Make sure the wire is connected.
4. Clean the engine cooling fins of grass and other debris.
5. Check the carburetor adjustments. See the "Engine Instrucllon Book'.
6. Check the spark plug gap. Set the spark plug gap ot 0.030".
7. Check the amount of oil in the engine. Fill with oil if necessary.
8. Check the engine air cleaner. See the =Engine Instruction Book'.
9. The gasoline is bad. Drain and cisan the fuel tank. Fillthe fuel tank with clean gasoline.
10. Check the throttle control. Make sure the lever is nut in the CHOKE position.
Excessive Vibration.
1. Remove the blade. Check the blade and balance if necessary. See the blade maintenance
instructions.
2. Check for a bent or broken blade. A DAMAGED BLADE IS DANGEROUS AND MUST BE
REPLACED.
3. Check the blade adapter. REPLACE A BROKEN BLADE ADAPTER.
4. If the vibration continues, take the mower to an Authorized Service Center.
The grass will not discharge correctly.
1. Clean the bottom of the mower housing.
2. Check for a badly worn blade. Remove and sharpen the blade. For safety, rapis_.e the blade
every two years with a factory replacement blade.
3. Move the thruttle control lever to the FAST poeltion. Check the speed of the engine according
to the "Engine Instruction Book'.
The grass is not cut even.
1. Check the haight adjustment at each wheel. The height adjustme_ must be the same for each
wheel.
2. Make sure the blade is sharp.
3. Check for a bent or broken blade. A DAMAGED BLADE IS DANGEROUS AND MUST BE
REPLACED.
4. Check for a broken blade adapter. REPLACE A BROKEN BLADE ADAPTER.
F-98534 24