Manual

PREPARATION
HOW TO MOUNT THE GRASS BAG
1. To mount the grass bag on the mower,
raise the rear door. Holdthehandle ofthe
grass bag. Put the grass bag in the
operating position (Figure 12). Lower the
rear door.
IMPORTANT: Make sura the hooks, on each
side of the frame assembly, are mounted
on the pivot rod.
WARNING: Do not use the grass
bag unless the cover is in the op-
erating postion.
Handle
Rear Door
Mount Frame
Hooks To Pivot Rod
Handle Bracket
Figure 12
HOW TO EMPTY THE GRASS BAG
WARNING: Before you remove
the grass bag, stop the engine.
_ Before you remove any grass
from the mower housing,
disconnect the wire from the
spark plug.
1. Hold the rear door. Raise the rear door to
a vertical position (Figure 12).
2. Lift the frame assembly over the two
handle notches.
3. Open the top cover (Figure 13). Empty the
grass from the grass bag.
4. To mount the grass bag on the mower, see
"How To Mount The Grass Bag".
Grass Bag
\
FINAL ASSEMBLY
Before you use the mower, check the
assembly of the wheels, the handle, and the
F-98527
15
controls. Make sure all the fasteners are tight.
Make sure the throttle control and the engine
stop lever work correctly.