Manual

1. Positionlowerhandleon housingso
cut-offflat is forwardas shown.
2. Align holes in handlewith holesin
housingas shownand assemble3/8-
16x 3/4 hexbolts,flat washers,and
Iocknuts.Tightensecurely.
3. Repeatfor oppositeside of mower.
Flat washers Lockr Jts
aex
bolts
\
Cut-off flat forward
ASSEMBLE WHEELS
Cutting height is determined by assem-
bling the wheels in one of four possible
positions on the mower housing. All
wheels must be in the same height posi-
tion for even cutting.
1. For each wheel, assemble shoulder
bolt and spacer as shown.
2. Assemble 1-1/4" diameter washers
(rear wheels only) and 3/8-16 Iocknuts
on inside of mower housing and tighten
securely.
1-1/4" diameter Washer
(Rear wheels only)
Mower housing
Shoulder Spacer
bolt
ASSEMBLE UPPER HANDLE
1. Position upper handle over lower
handle with small hole for mounting
up-stop bracket to right side and as-
semble 1/4-20 x 1-1/2 hex bolts and
1/4-20 Iocknuts. Tighten securely.
ASSEMBLE UPSTOP BRACKET
2. Position upstop bracket on the right
inside of upper handle as shown.
3. Install the hex washer head screw into
the hole in up-stop bracket and upper
handle. Tighten securely.
AS VIEWED FROM FRONT OF MOWER
Up-stop
bracket
aex
washer
head
SCOW
f_
\
3/8-16
Wheel Locknut
ASSEMBLE DISCHARGE GUARD
1. Place discharge guard on top of lawn
mower discharge opening.
2. Install two (2) 1/4-20 x 3/4 hex bolts
through housing and discharge guard.
3. Install two (2) 3/4" diameter washers
and two (2) 1/4-20 Iocknuts. Tighten
securely.
Locknuts
Washers
Discharge guard __________
Hex bolts
7