Manual

Throttlecontrol Controlbar Controlbar Upper
(Ifequipped) handle
1/4-20 Machine
screw Cable
or hex bolt ties
supplied
ASSEMBLE STARTER ROPE GUIDE
(USE HARDWARE GROUP "G")
CENTER MOUNT TYPE
• Install threaded end of rope guide
through hole in top of lower handle
crossbar.
• Loosely assemble 1/4-20 keps Iocknut
on threaded portion of rope guide. Do
not tighten.
• Hold control bar against upper handle
and slowly pull starter rope out and up
over lower handle crossbar and slip into
loop of rope guide.
• Push rope guide down against crossbar
and tighten nut securely.
Engine starter rope
Rope guide
Lower handle
1/4-20 Keps Iocknut
Engine
starter rope
SPARK PLUG BOOT (IF EQUIPPED)
(NO HARDWARE REQUIRED)
On some model lawn mowers a spark plug
boot is packed loose in the parts bag. If
your model has one, install it on spark plug
wire and then reconnect plug to spark plug.
©
Spark
Spark plug wire
Boot
ASSEMBLE GRASS CATCHER
(REAR DISCHARGE MODELS ONLY)
(NO HARDWARE REQUIRED)
• Put grass catcher frame into grass bag
with rigid part on bottom.
• Slip vinyl bindings over frame. If bind-
ings are too stiff, hold them in warm
water for a few minutes. Allow bag to
dry before using.
_ _ __ Frame
SIDE MOUNT TYPE
• Put threaded end of rope guide through
hole in side of upper handle above lower
handle crossbar. Secure with 1/4-20
keps Iocknut.
• Hold control bar against upper handle
and slowly pull starter rope out until rope
will slip into loop of rope guide.
Vinyl
15 bindings
Frame
opening