Manual

MODELS WITH SPARK PLUG TO REAR
OF MOWER
To prevent cable damage, the cable must
be attached to the side of engine, away
from the muffler.
• Above the muffler, locate the hole in en-
gine shroud. Install supplied cable clip
on cable and assemble to side of engine
with supplied hex head screw. Tighten
securely.
MODELS WITH TECUMSEH ENGINE
• Straighten cable and find the end with
the small tapered plastic fitting.
• Hook the "Z" bend fitting on inner wire of
cable into hole as shown.
• Align the tapered end of the plastic fitting
with the hole in the mounting bracket
and push in until fitting snaps into place.
• Route cable under crossbar portion of
lower handle and up to upper handle
control bar.
• Hook "Z" bend fitting on inner wire into
hole in control bar (See "ASSEMBLE
CABLES TO UPPER HANDLE" in this
manual).
TECUMSEH ENGINES
WITH SPARK PLUG FORWARD
Mounting
bracket
Small
fitting X
TECUMSEH ENGINES
WITH SPARK PLUG REARWARD
Z" Fitting
MODELS WITH BRIGGS & STRATTON
QUANTUM ENGINES
• Hook the "Z" bend fitting on inner wire
of cable (end with tapered plastic fitting)
into hole in brake lever of engine. Cor-
rect brake lever to use is determined by
position of spark plug on your mower
- forward or rearward.
• Position the tapered plastic fitting into
the mounting bracket on engine. Snap
fitting into place.
• Route cable under crossbar portion of
lower handle and up to upper handle
control bar.
• Hook "Z" bend fitting on inner wire into
hole in control bar (See "ASSEMBLE
CABLES TO UPPER HANDLE").
Brake lever (rearward spark plug) Brake lever
(forward spark
plug)
Mounting bracket
(rearward spark plug)
Mounting bracket
(forward spark plug)
ASSEMBLE CABLE(S) TO UPPER
HANDLE
(USE HARDWARE GROUP "F")
• Assemble cable(s) to opposite side of
upstop bracket.
• Be sure to route cable(s) underneath
crossbar of lower handle.
• Position throttle control (if equipped)
on outside of handle and zone control
square fitting on the inside.
• Secure to handle with the 1/4-20 ma-
chine screw or hex bolt supplied and
Iocknut as shown. Tighten securely.
• Secure cable(s) to crossbar and lower
handle with cable ties as needed.
"Z" Fittinc
Mountinc
bracket
plastic
fitting
14