Manual

MODELS WITH SPRING LOADED
DISCHARGE GUARD
• Place discharge guard on top of lawn
mower discharge opening.
• Install two (2) hex self-tapping screws
through housing and into guard mount-
ing bracket or, install two (2) 1/4-20
Iocknuts (If equipped). Tighten securely.
/' \\
CHOKE
/
!
Discharge
guard
Locknuts ____--_-
INSTALL CONTROL BAR
(NO HARDWARE REQUIRED)
• Position control bar so flattened section
with hole is on opposite side of upstop
bracket.
• Insert one end of control bar into hole be-
hind upstop bracket. Carefully push in on
opposite end of control bar and insert into
formed hole on inside of upper handle.
FAST / START
I //._ \
I i. I I I
!
I " II
/ !
/
!
Control
bar
Upstop
bracket
ASSEMBLE REMOTE THROTTLE
CONTROL TO ENGINE
(ON MODELS SO EQUIPPED)
(USE HARDWARE GROUP "E")
If your mower does not have a remote throttle
control, go on to"ASSE M BLE ENGINE ZONE
CONTROL CABLE TO ENGINE".
• First, move lever on remote throttle
control to the CHOKE (if equipped) or
FAST/START position.
12
Determine the manufacturer and brand or
type engine on your lawn mower and follow
the appropriate instructions that follow.
MODELS WITH BRIGGS & STRATTON
CLASSIC OR SPRINT AND TECUMSEH
ENGINES
NOTE: Tecumseh engines have cable
mounting clamp and screw preassembled
on engine.
• At engine carburetor, insert wire "Z"
bend of throttle control into hole of
speed lever (use inner hole on Briggs &
Stratton engine).
• (Briggs & Stratton only) Assemble di-
ecast clamp and #10 x 5/8 screw loosely
to engine.
Position throttle cable under clamp and
push cable towards speed lever until speed
lever touches boss. Hold cable at this po-
sition and tighten clamp screw securely.