Manual

SIDE DISCHARGEMOWERS
Tabhole 1-1/4"Washer(Ifsupplied)
Locknuts
TYPE I
Right rear/left front
height adjuster
TYPE
Right front/left rear height adjuster
REAR DISCHARGE MOWERS
Tab hole
INSTALL DISCHARGE GUARD
(SIDE DISCHARGE MODELS ONLY)
(USE HARDWARE GROUP "D")
If your mower is a rear discharge mower,
go on to "INSTALL CONTROL BAR".
MODELS WITH BOLT-ON GUARD
NOTE: If your discharge guard has ribbing
as shown in the illustration below, there
are two (2) spacers which must be placed
between guard and mower housing.
• Place discharge guard on top of lawn
mower discharge opening.
• Install two (2) 1/4-20 short hex bolts
through housing and discharge guard.
• Install two (2) 3/4" washers and two
(2)1/4-20 Iocknuts. Tighten securely.
Tab hole 1-1/4" Washer (If supplied)
_t_k!_ <" b_ I \, Locknuts
Right rear/left front __. _ T
height adjuster _._?_:__: /
TYPE II _*''""""_
Right front/left rear height adjuster Tab hole
ASSEMBLE WHEELS TO ADJUSTER
AXLE ARMS
• Secure each wheel with flat washer
and retainer spring or flange Iocknut (if
equipped with threaded axle).
• Assemble adjustment knobs to adjuster
levers by pressing or tapping lightly.
• If your mower is equipped with hubcaps,
install by pressing or tapping lightly until
hubcap snaps securely over flat washer.
Wheel
Flat washer
Axle arm
\
Retainer
sprir,
\
Hubcap (If epuipped)
Adjustment
knob
-lange Iocknut
(If equipped with
threaded axle arm)
11
BOLT-ON GUARD WITH RIBBING
Washers
Discharge
guard
ribbing
Hex bolts _/
BOLT-ON GUARD WITHOUT RIBBING
_ Locknuts
Discharge _/_' 1
guard
Hex bolts_ _