User guide
39
Reset conguration
If you have forgotten the Admin PIN code, the only way to reset it to default is to do a
hard factory reset. This is the same as the Factory reset in the system menu (MENU >
SYSTEM > FACTORY RESET).
This erases all settings including account information and contacts!
Disconnect the power supply cable. Note that this is the same as the network cable if
the phone uses Power over Ethernet.
Press and hold the MENU button while you connect the cable again (i.e. starts the
Konftel 300IP). Hold the button pressed until the SYSTEM RECOVERY menu is shown
on the display.
You can press any other button than 1, 2, or 3 to start the phone without resetting.
Press 1 to select Reset conguration and conrm with OK.
Upgrade to the latest version of the software when the phone has started and redo the
setup of account and other settings (see page 7).
Restore rmware
This replaces the current software with the one supplied with the phone. All settings are
erased.
Disconnect the power supply cable. Note that this is the same as the network cable if
the phone uses Power over Ethernet.
Press and hold the MENU button while you connect the cable again (i.e. starts the
Konftel 300IP). Hold the button pressed until the SYSTEM RECOVERY menu is shown
on the display.
You can press any other button than 1, 2, or 3 to start the phone without restoring the
rmware.
Press 3 to select Restore rmware and conrm with OK.
All content in the phone’s memory is erased and the rmware supplied with the phone is written to
the memory.
Upgrade to the latest version of the software when the phone has started and redo the
setup of account and other settings (see page 7).
HARD SYSTEM RECOVERY