Specifications

Section 20 00-02-2003
06-21-10 - 11 -
External Standard Accelerometer Wiring
1. Remove the EVS EX top cover.
2. Connect the Power and Relay wires per instructions above.
3. Place a slotted screw driver in the slot of the 3-pin connector. Pry the screw driver
away from the back of the connector until the connector comes loose from the header.
4. Lift the connector off the header.
5. Connect the external accelerometer wires as indicated in the pin out diagram below.
Standard External
Accelerometer Wiring
PHASE OUT / DISCONTINUED
Check Availability