Specifications

Section 20 00-02-2003
06-21-10 - 7 -
Vertical and Horizontal Installation
1. Make sure you read the bearing or equipment manufacturers instruction for drilling
and tapping equipment casing or housing before installing the EVS EX.
2. Drill and tap four holes for the four (1/4” x 20) bolts that fasten the EVS EX to the
equipment casing, bearing housing or mounting plate.
3. Clean the mounting surface making sure there is no debris on the surface.
4. Align the EVS EX over the tapped holes.
5. Place one lock washer and one flat washer on each of the ¼” bolts.
6. It is highly recommended that you apply Loctite® #242 to the bolt threads prior to
installation.
7. Screw the bolts into the casing or housing until finger tight.
8. Use a torque wrench and tighten each bolt to a minimum of 70 inch pounds. Torque
requirements may vary depending on the material you are attaching the EVS EX to.
Vertical Installation Horizontal Installation
PHASE OUT / DISCONTINUED
Check Availability