User`s manual

-10-
9.4 DESCRIPTION OF STATUS MESSAGES SHOWN ON MULTIFUNCTION DISPLAY
9.4.1 FOR UTILITY
(9)
Status Message Description
U-AbSt Utility is Absent
U-RdY Utility is Ready
U- VX Utility Voltage error (Over/under voltage, phase failure)
U- FX Utility Frequency error (Over/under frequency)
U- SX Utility Sequence error
U-W 10 Utility is being restored with count down
U-X 10 Utility is counting Transfer Dead Time with count down
U-OnLd Utility is Feeding Load
9.4.2 FOR GENSET
Status Message Description
StndbY Genset ready but Remote Control is absent
REAdY Genset ready
NotRdY Genset not ready
RSP 10 Engine Counting Response delay with count down
PHT 10
(
10
)
Engine Preheating with count down
CRANKG Engine Cranking
RUNING Engine running
WUP 10 Engine Warming Up with count down
XFR 10 Engine counting Transfer Dead Time with count down
OnLoad Engine running on load
SLd 10 Engine Shutting Load with count down
CoL 10 Engine Cooling with count down
SEG 10
(
11
)
Shutting Engine with count down
Fault A fault has occurred on the Genset
Hi-Oil T High oil temperature Fault
E-StoP Emer
g
enc
y
stop
St Fail Fail to start Fault
Ph Fail Genset Phase failure Fault
SQ Fail Genset Sequence failure Fault
bat-Hi High battery Fault
bat-Lo Low battery Fault
oFREQ Genset Over frequenc
y
Fault
uFREQ Genset Under frequency Fault
oVolt Genset Over voltage Fault
uVolt Genset Under volta
g
e Fault
oVLoad Overload Fault
-----L Fuel Level (Available only when CAN is enabled)
----rPM Rounds per minute
(
Available onl
y
when CAN is enabled
)
---L/H Fuel Consumption Rate (Available only when CAN is enabled)
---Add CAN Address (Available only when CAN is enabled)
9
Available only for Surf-AMF
10
Available only if one of the outputs is set to Preheat
11
Available only if one of the outputs is set to Cut-Off