Owner Manual

8
MurphyDoor.com888-458-5911
20
1817
19
1615
PLEASE READ INSTRUCTIONS FULLY BEFORE YOU BEGIN INSTALLATION
Secure with (5) 1-1/4" truss head screws (D) making sure not
to drill through other side of front casing.
Congratulations.
This concludes the Unassembled Murphy Door Flush Mount
installation procedure.
Run a bead of glue down the face frame of the door to
strengthen the left casing.
Using a 1/8" drill bit pre-drill ve holes into the left support
face frame. This will make it easier to attach the left side
casing.
Position the left side casing. Test the door swing prior to
screwing in to ensure it doesn’t make contact with the oor.
Attach the right casing onto the door jamb with a 1/2" overhang
on the door face frame.
For an out-swing door, center the top casing over the door
leaving a 1/16" clearance over the door itself. Attach using a
brad nailer.
Out-swing Casing
Out-swing Casing
Out-swing Casing
Out-swing Casing
Out-swing Casing