Owner Manual

MurphyDoor.com888-458-5911

7 8

PLEASE READ INSTRUCTIONS FULLY BEFORE YOU BEGIN INSTALLATION

It is critical that the bottom threshold and jamb sides are

level. If the door jamb is not level and plumb the door will not

swing and close properly.

Note: The bottom threshold SHOULD NOT be installed over carpeting.

Carpet will aect levelling and prevents proper function of the door.

Using a 1/8" drill bit, pre-drill and countersink three holes

into each side of the jamb, 2" from the top of the jamb,

2" from the bottom of the jamb, and in the middle. Next

predrill and countersink two holes into the jamb top, 6" from

the right and left sides of the jamb.

Using shims where needed, install (8) 3" screws (F) making certain

the top and sides of the jamb are level.

Note: The screws included are meant for a wood frame. If installing the

jamb into a steel frame, replace the screws with (8) 3" self tapping screws.

Place the door into the door jamb, making sure that the

bottom pivot hinge sits in the silver thrust bearing.

Press down on the ball lock of the hinge pin to retract the

two top pins.

Place the door jamb into the rough opening. The bottom

jamb threshold should extend into the room toward the

back of the bookcase.