Owner Manual
2
MurphyDoor.com888-458-5911
PLEASE READ INSTRUCTIONS FULLY BEFORE YOU BEGIN ASSEMBLY
BEFORE YOU START
• If you are not installing door on receipt keep it standing level on its base or lay
it at. DO NOT lean it against a wall on its edge.
• Proper moving (MURPHY DOOR IS NOT RESPONSIBLE FOR DROPPED DOOR DAMAGE)
- Take door/cabinet out of jamb and carry cabinet and jamb separately.
- DO NOT carry or lift by face frame.
- The doors are heavy, handle with care.
- Support the entire door when carrying and lifting the door.
- Minimum of two persons recommended.
• Make sure all instructions are read and understood by installer prior to installing
your door. Our doors are unique and have particular nishing details.
- The cabinet is 1-1/2" to 2" narrower than the jamb. This allows for proper
function of the door. Gaps will be covered by nish casing.
- In-swing and out-swing casing and hinges are placed dierently.
- There will be some wall nishing needed where the wall meets the jamb.
For best results prep the wall with the sheet rock edge cut as straight and
clean as possible.
• Verify that you have all parts prior to starting the installation or hiring a contractor.
• Test your pin to make sure it works properly.
- Hold the pin while pushing the center button. The two ball bearings
should retract slightly. If the ball bearings do not retract spray with dry
lube. Engage the center button several times. Recheck to see if pin
is working properly.
DO NOT USE IF PIN ISN’T WORKING PROPERLY.
UNINSTALLING DOORS
Out-swing Door
• Take pressure o the door. The pin must be vertical and the holes of the hinges
must be aligned. If there is too much friction, the pin will not easily slip out of
the hinges.
• Locate hinge pin in the top of the cabinet through a 1" hole.
• Put the hinge pin removal tool up around the pin.
• Carefully pull the pin down as you slightly wiggle the removal tool.
• Once top pin is out, you can lift the door o the bottom hinge.
In-swing Door
• Take pressure o the door.
• Pin will be mounted to the side of the door.
• Push the button on the pin, while pulling the pin down as you wiggle it down and out.
• Once top pin is out, you can lift the door o the bottom hinge.
If you lose the pin removal tool, you can order another at MurphyDoor.com
Taping the pin removal tool to the xed shelf can be a simple solution.