Specifications

2-46
2.4.15.3 Fusing Temperature Control
•
The Fusing Roller Heater Lamp inside the Left Fusing Roller provides the following temperature control.
200
185
Approx.
5 min.
Approx.
1 min.
Mode 1 Mode 2 Mode 3
Warm-Up
Completed
(200˚C)
- Temperature Control During Standby State -
210
200
190
180
175
Approx.
5 min.
Approx.
1 min.
Mode 1 Mode 2 Mode 3
Special paper
Plain paper (1-sided)
Plain paper (2-sided)
Transparencies
- Temperature Control During a Copy Cycle -
<Temperature Control>
•
The Fusing Roller Thermistor detects the surface temperature of the Left Fusing Roller.
It provides an analog voltage input to the Master Board allowing the machine to control the fusing
temperature.
Electrical Component Control Signal ON OFF
H1
PJ16A-8
See block diagram of the printer.
LH
Electrical Component Control Signal
Low Temp.
↔
High Temp.
TH1
PJ16A-5
See block diagram of the printer.
Analog input