Specifications

Second phone line Options
6-95
Unique Switch d:2 – Modem
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 1 Factory use only
3 0 Factory use only
2 1 ANSam output time
0: 3 sec
1: 4 sec
The time limit to output the ANSam (A sinwave
signal at 2100 Hz amplitude-modulated). Sets to “1”
when the V.8 handshake is hard to achieve.
1 0 Factory use only
0 1 Factory use only
Unique Switch d:7 – Modem
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 If retraining occurs due to the low reception signal
level and few delay of the telephone line, it may
overlap the second post-message. In this case,
increase the delay before the post-message is
transmitted.
30
The delay before post-
message is transmitted
0 ms 100 ms 200 ms 300 ms
Switch 4:0011
Switch 3:0101
2 0 Factory use only
1 0 Factory use only
0 0 Factory use only
Unique Switch i:4 – Miscellaneous
Switch
Initial
Setting
Adjust Usage/Comments
70
60
50
Set the time to change the display between the first
and second phone lines during the second phone
line is communicating.
When set to “0”, show only the line during
communication.
4 0 Switch 76543210 Time
11111111 2550 sec
3 0 11111110 2540 sec
11111101 2530 sec
21 :
00000101 50 sec
10 :
00000011 30 sec
01
Time to change the display
between the first and second
phone lines. (sec)
00000010 20 sec
00000001 10 sec