Specifications

Options 2-Bin/Shift Tray
6-68
6.6.2 DIS/REASSEMBLY, ADJUSTMENT
Precautions for Disassembly, Reassembly, and Adjustment
• Before attempting to disassemble the unit, always make sure that no power is being supplied from the
machine (by unplugging the power connector from the machine).
• While power is being supplied to the unit, do not attempt to remove/install the print jacks from/to the
PWBs or unplug/plug in the connectors.
• If the unit is run with its covers removed, use care not to allow your clothing to be caught in revolving
parts.
• The basic rule is do not run the unit with any of its parts removed.
• A toothed washer is used with the screw that secures the ground wire to ensure positive conduction. Do
not forget to include this washer at re-assembly.
• To reassemble the unit, reverse the order of disassembly unless otherwise specified.
• Do not attempt to remove or loosen the screws to which red paint has been applied.
6.6.2.1 Disassembly
6.6.2.1.1 Removal of the Exterior Covers
<2-Bin Tray>
1. Rear Cover: Loosen four screws and slide the cover toward to the rear.
2. Top Cover: Remove the Front and Rear Covers and lift the cover upward.
3. Front Cover: Remove the Lower Front Cover, loosen four screws, and slide the cover to the front.
4. Lower Front Cover: Unlock the tabs and slide the cover to the front.