Specifications

3-117
Unique Switch g:4 - Remote reception
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Load 24V to TEL 2 line
0: No
1: Yes
When set to “1”, 24 V will be loaded to TEL 2 in
communication.
Note:
Set to “1” in g:4 bit 0 when make this feature
available.
3 0 Factory use only
2 0 Factory use only
1 0 Factory use only
0 0 Set the relay of TEL 2 in
Silent receiving
0: On
1: Off
When set to “1”, TEL 2 does not ring in the silent
receiving.
Unique Switch g:5 ∼ g:6 --- Factory use only
Unique Switch g:7 – Remote reception and TAD interface
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 Strict condition of CNG
detection after OGM output
0: No
1: Yes
When set at “1”, the condition of CNG detection
becomes strict. CNG should be detected 2times
continuously and the OFF time should be 2
∼
4 sec.
4 0 CNG detection during OGM
output in ANS Ready
0: Yes
1: No
3 0 Number of detection DTMF Sets the number of detection the DTMF during
Ans/Fax Ready mode.
Switch 3 2 1 0 Number of detection
0 0 0 0 Not detect
2 0 0 0 0 1 1
0 0 1 0 2
0 0 1 1 3 Initial setting
0 1 0 0 4
0 1 0 1 5
1 1 0 1 1 0 6
0 1 1 1 7
1 0 0 0 8
1 0 0 1 9
1 0 1 0 10

0 1 1 1 1 1 15
Unique Switch g:8 ∼ g:9 --- Factory use only