Specifications

3-109
Unique Switch e:0 - Scanner
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 1 Transmit a small document at
center
0: No
1: Yes
When set to “1”, the image will transmit at center
even when you put the small document along the
edge.
5 0 Scanning standard point of
ADF
0: Front left
1: Rear left
When set to “0”, the document is scanned from the
front left point and the rear part can be missed in
the case that the image is larger than the recording
paper.
When set to “1”, the front part can be missed.
4 0 Factory use only
3 0 Factory use only
2 0 Factory use only
1 0 Factory use only
0 1 Hyper fine resolution
0: No
1: Yes
When set to “1”, Super fine resolution (203 dpi ×
392 lpi) changes into Hyper fine resolution (406 dpi
× 392 lpi).
Unique Switch e:1
Switch
Initial
Setting
Adjust Usage/Comments
7 1 Set the fixed ratio for copy
and the auto ratio in detail
0: No
1: Yes
When set to “1”, the ratio will be calculated in detail
automatically according to the document size and
the recording paper size.
6 1 Factory use only
5 0 Factory use only
4 0 Factory use only
3 1 Factory use only
2 0 Rotate B5 document and
store it as B5
0: Not rotate
1: Rotate
This is available when the rotate transmission is set
to ON.
1 0 Rotate A5 document and
store it as A5
0: Not rotate
1: Rotate
This is available when the rotate transmission is set
to ON.
01
Rotate A4
document and
store it as A4
0: Not rotate
1: Rotate
This is available when the rotate transmission is set
to ON.
Unique Switch e:2
∼
e:5 --- Factory use only