Specifications

3-102
Unique Switch b:5 - Transmission
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 The length of the
communication failure report
in Relay broadcast (unique)
0: A4
1: No limit
Determine the length of the communication failure
report in Relay broadcast.
Note:
This is available only when you set Unique
Switch i:3 bit 7 to “1”.
4 0 Send the result of Relay
broadcast (unique) to the
sender unit when the
communication failure
occurred
0: No
1: Yes
Send the information of the unit which had a
communication failure in Relay broadcast to the
sender unit.
Note:
This is available only when you set Unique
Switch i:3 bit 7 to “1”.
3 0 Factory use only
2 0 Factory use only
1 0 Factory use only
0 0 Factory use only
Unique Switch b:6 - Transmission
Switch
Initial
Setting
Adjust Usage/Comments
7 1 Available *, # and space
upon
F-code box registration
0: No
1: Yes
Determines if the * (asterisk), # (sharp) and space
are available upon
F-code box registration.
61
Available *, # and space
upon
F-code communicating
0: No
1: Yes
Determines if the * (asterisk), # (sharp) and space
are available upon
F-code communicating.
5 0 Ignore space in F-code ID
0: Yes
1: No
Determines if checking the space stored in the
F-code ID.
4 1 F-code sub-frame off
0: Send
1: Not send
Do not send the sub-address and password of F-
code box when a point of sending DCS signal after
EOM signal.
3 0 Send F-code box’s TTI
0: No
1: Yes
Transmit the sub-address and box name of F-code
box with F-code polling document.
2 0 Factory use only
1 0 Retrieve document
0: No
1: Yes
Retrieve the document received in F-code
SecureMail box by polling transmission.
0 1 Ignore F-code bit
0: No
1: Yes
Neglect SEP bit of DTC signal or SUB bit of DCS
signal at F-code polled transmission.
Note:
The “F-code communication” is possible the SecureMail and Polling operation using the F-code
(SUB/SEP/PWD/SID). However, it is not based on T.33 recommendation.