Specifications

3-85
Memory Switch B:5 - Transmission
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Program individual autodialer
attributes
0: No
1: Yes
Allows individual setting of memory switches B:0 as
attribute 1, B:1 as attribute 2, B:2 as attribute 3 and
B:3 as attribute 4 when one-touch and speed dial
locations are programmed. (Refer to page 3-97 for
settings.)
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Factory use only
2 0 Sending RTC signal when
transmission is canceled
0: Yes
1: No
RTC signal is sent at the end of the transmission.
When set at “0”, the machine will send the RTC if
the transmission is canceled. No error will occur.
When set at “1”, an error will occur because RTC
will not be sent at the end of a canceled
transmission.
1 1 Cancel redial if T.4.1 or T.4.4
error occurs
0: Yes
1: No
When set at “0”, if a T.4.1 or T.4.4 error occurs, the
machine will not retry the transmission.
0 0 Action after EOR signal
0: Continue
1: Discontinue
Sets action after receiving PPR four times at 2400
bps.
Memory Switch B:6 ∼ B:9 --- Factory use only
Memory Switch C:0 - Reception
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Data error rate
0: 10%
1: 20%
Determines the allowable number of erred lines out
of total lines received in a document.
6 0 Pause one second after
sending CED
0: No (75 ms)
1: Yes (1 sec)
A 2100 Hz CED signal disables echo suppression in
some telephone equipment. When set to "1", the
machine pauses one second after sending CED,
which allows echo suppression to restart. This may
help with problematic overseas reception.
5 0 Factory use only
4 0 Factory use only
3 1
2 1
1 0
0 1
Receive speed (kbps)
Maximum receive speed may be slowed to compensate for poor phone lines.
2.4 4.8 7.2 9.6 12 14.4 16.8 19.2 21.6 24 26.4 28.8 31.2 33.6
0 0 0 0 0 0 0 0 1 1 1 1 1 1
0 0 0 0 1 1 1 1 0 0 0 0 1 1
0 0 1 1 0 0 1 1 0 0 1 1 0 0
0 1 0 1 0 1 0 1 0 1 0 1 0 1