Operating instructions

When messages are displayed
This is a summary of important messages.If a message not listed here is displayed,
take corrective action by following the instructions in the message.
Message on the LCD What it means/What to do
ADF is not When use the series copy function, the document is set in
available. the ADF.You cannot use the ADF for series copy.
Set document Remove the document from ADF, then set the document
on FBS on FBS glass.
Auto doc. size Non-standard size document is set.Your machine can
detection failed. detect Letter , Legal , Half-letter and
11″×17″(ledger ) sized document only.
Pressing START to copy your document to the auto selected
paper. Or, press STOP then select paper manually by using
the [Paper]. And then try again.
...or ...
Document is not set. Set your document.
Check paper size The paper size setting is incorrect.
Check the paper size and set the proper paper size.
Call for service The scanner lamp is dim or inoperable.
Make repeated copies to help evaporate any internal
moisture. If that doesn’t resolve the problem, call your
authorized Muratec dealer or Muratec Customer Support.
Copy protected You tried to use your machine to make a copy, but the
unit’s copy protection feature is on,preventing such use.
Turn off copy protection. (See “Copy protect” on page 1.22
in General reference.)
Disable to set You cannot set the reduce/enlarge ratio during the
ratio during directional magnification function is set.
D.Mag. is set.
Memory is not enough The copying was stopped because of memory overflow.
The last xxx page Please copy again from indicated page.
was erased.
Please copy again.
Not available with You have set two functions that conflict with each other.
xxxx Cancel either one of the two functions.
Please call service The printer unit of your fax machine has become inopera-
ble. Call your authorized Muratec dealer or Muratec
Customer Support.
Please wait Your fax machine’s printer is either warming up or busy.
Please wait until the fax is finished printing and then re-
try your command or operation.
Rotate document In combine, repeat, series copy or booklet
by 90° or set ratio function, the document is set in the incorrect direction.
Set the document in the rotate by 90° or set the
reduce/enlarge ratio.
Set document in ADF In Booklet copy, you cannot use the FBS glass.
Set your document in ADF for Booklet copies.
No paper size There is no paper that matches the reduce/enlarge ratio.
is suitable. Press STOP then select paper manually.
Copying with auto
selected paper.
The machine is not functioning as designed
Symptom Check for/What to do
The LCD shows nothing. Is only the ENERGY SAVING key lit up green?
The machine is in the Energy Saver mode. Press any key
on the control panel to cancel.
...or ...
The power switch is turned OFF.
Turn the power switch ON.
...or ...
The LCD contrast volume is turned to the excessively light
or dark position.
Viewing the LCD , adjust the LCD contrast volume as neces-
sary.
Control panel keys Is only the ENERGY SAVING key lit up LED ?
do not respond. The machine is in the auto power off mode.
Press ENERGY SAVING key on the control panel to cancel.
...or ...
The power switch is turned OFF.
Turn the power switch ON.
Trouble shooting
4.1