Operating instructions

1.7
Getting started
Automatic document size detection for auto paper selection
Your machine can automatically detect the following size of your document and
select a suitable sized paper to copy your document.
•11″ × 17″
• 8.5″ × 14″
• 8.5″ × 11″
• 5.5″ × 8.5″
If the suitable sized paper is not set in the paper cassette, the LCD shows:
If you want to copy with the paper the machine auto-
matically selected, press START .
If you want to copy with other size paper, press STOP
to cancel this operation, then set the suitable paper in
the cassette or adjust the Reduce/Enlarge ratio.
If you set the non-standard sized document or the machine could not detect the doc-
ument size, the LCD shows:
If you want to copy with the paper that the machine
automatically selected, press START .
If you want to copy with other sized paper, press STOP
to cancel this operation, then set the suitable paper in
the cassette or adjust the Reduce/Enlarge ratio.
Manual paper select
You can select the paper manually by pressing [Paper] or using the cursor key.
Note: If the optional multi-paper tray is attached, you can select the multi paper
tray, see “Using the bypass tray” ⇒ Page 1.10.
Rotate copy
When the document is set at a different direction from the recording paper in the
paper cassette with auto paper select mode on, the machine automatically rotate
the scanned image by 90° to match the recording paper direction. However, this
applies to the 8.5″ × 11″ size paper only.
Note: Rotate copy is not available with the following functions:
• Combine copy
• Repeat copy
• Directional Magnification copy
• Copying from multi-paper tray
• Copying with non standard sized paper