Operating instructions

1.18
Getting started
Acceptable document size
The acceptable dimensions as follows:
Automatic document feeder ( ADF ) (width ×length)
S INGLE - SHEET M ULTIPLE - SHEET
Maximum: 11.8″ ×35.4″ (Tx) 11.0″ ×17.0″
11.8″ ×17.7″ (Copy)
Minimum: 4.7″ ×3.9″ 8.5″ ×5.5″
Weight: 30.2 – 104.7 g/m
2
52.3 – 104.7 g/m
2
You can set up to about 50 sheets of letter-,40 sheets of legal- or 30 sheets of
11″ × 17″sized document in the ADF at a time.
Flatbed scanner ( FBS ) glass (width ×length)
Maximum: 11.0″ × 17.0″
Things not to put in your machine
To avoid paper jams and damage to your machine,don’tinsert:
•Folded,curled,torn,wrinkled or very thin pages
•Documents with staples,glue,tape,paper clips or still-wet correction fluid
•“Sticky notes”(or documents with “sticky notes”attached)
•Cardboard,newspaper or fabric
•Pages with duplicating carbon on either side
•Credit cards or any small,thick items
How to set the document
When set the documents in the Automatic Document Feeder
1
Set your document face up into the docu-
ment feeder.The document should be
aligned to the rear left corner.
2
Adjust the document guide to fit your docu-
ments.
Note:You cannot set the different sized docu-
ment at a time.
When set the documents on the FBS glass
1
Lift the platen cover fully.
2
Set your document face down
on the FBS glass.The document
should be aligned to the rear
left corner.
3
Gently close the platen cover.
Note:If you do not lift the platen
cover fully,the document size
will not be detected automatically.
Auto document size detection
The following sized documents are automatically detected.
•Letter(8.5″ × 11″)
•Legal(8.5″ × 14″)
•Ledger(11″ × 17″)
•Half-letter(5.5″ × 8.5″)
How to set the document