Specifications

5-77

5.3.7 ADF zoom adjustment (Vertical)

Note: Note: This adjustment must be made after the adjustments of printer registration (top and side) of the 1st cassette

have been made.

The difference should be within ± 1.0 % of the actual length of A on the test chart No. 2003-01. Adjust so that the

following specifications are satisfied with the length of A on the test chart No.2003-01.

Zoom ratio Standard Adjustment Tool Setting Range

100 % ± 1.5 % Machine parameter:012

– 1.5 to 1.5 %

(0.1 % step)

Adjustment procedure

1. Load legal (for USA version) or A4 (for GBR version) size paper to the first cassette.

2. Place the Muratec Test Chart No. 2003-01 on the ADF.

3. Make two copies on paper in the 1st cassette with 100 % magnification.

4. Measure the length of A on the second copy to find the difference.

If length A falls outside the specified range, perform the following steps to make the adjustment.

5. Enter Machine Parameter mode. (Press MENU, *, 0, 0)

6. Adjust so that the setting of Machine Parameter 012 meets the specification.

If the length A is shorter than the standard, increase value.

If the length A is longer than the standard, decrease value.