Specifications

3-61
Unique Switch 15 - Transmission
Switch
Initial
Setting
Adjust Usage/Comments
7 0
Not used
6 0
Not used
5 0
Factory use only
4 0
Factory use only
3 0
Not used
2 0
Not used
1 0
Not used
0 0
Factory use only
Unique Switch 16 - Transmission
Switch
Initial
Setting
Adjust Usage/Comments
7 1
Available *, # and space
upon F-code SUB/SEP
registration
0: No
1: Yes
Determines if the unit checks the * (asterisk), #
(sharp) and space upon F-code SUB (sub-
addressing) /SEP (password) registration.
6 1
Available *, # and space
upon F-code communicating
0: No
1: Yes
Determines if the unit checks the * (asterisk), #
(sharp) and space upon F-code communicating.
5 0
Available space in F-code ID
0: No
1: Yes
Determines if the space is checked in F-code ID.
4 1
F-code sub-frame off
0: Send
1: Not send
Do not send the sub-address and password of F-
code box at the point of sending DCS signal after
EOM signal.
3 0
Send F-code box’s TTI
0: No
1: Yes
Transmit the sub-address and box name of F-code
box with F-code polling document.
2 0 Not used
1 0
Retrieve document
0: No
1: Yes
Retrieve the document received in F-code
SecureMail box by polling transmission.
0 1
Ignore F-code bit
0: No
1: Yes
Neglect SEP bit of DTC signal or SUB bit of DCS
signal at F-code polled transmission.
Note: The “F-code communication” is possible the SecureMail and Polling operation using the F-code
(SUB/SEP/PWD/SID). However, it is not based on T.33 recommendation.