Specifications

4
Machine Parameter 17
Switch
Initial
Setting
Adjust Usage/Comments
7 0
6 0
5 0
4 0
3 0
2 0
1
0
0 0
Leading edge document
margin adjustment
(ADF)
Adjusts the leading edge
margin from Document
Sensor 2 (DS2) to the start of
the scanning position.
Each setting changes
by 0.0649 mm.
Note: These values are
factory set and should not be
adjusted unless instructed by
a Muratec technical
representative.
Note: Total value of Machine
parameters 03 and 17 will
effect the “Leading edge"
document margin adjustment
(ADF)”.
Switch 76543210 Settings
10111111 - 4.0887 mm
10111110 - 4.0238 mm
 
 
10000010 - 0.1298 mm
10000001 - 0.0649 mm
00000000 0.00 mm
00000001 0.0649 mm
00000010 0.1298 mm
 
 
00111110 4.0238 mm
00111111 4.0887 mm
Initial Setting TBD
Machine Parameter 18
Switch
Initial
Setting
Adjust Usage/Comments
7 0
6 0
5 0
4 0
3
0
2 0
1
0
0
0
Trailing edge document
margin adjustment.
(ADF)
Adjusts the document feed
after the trailing edge of a
document passes
Document Sensor 2 (DS2).
Each setting changes
by 0.0649 mm.
Note: These values are
factory set and should not be
adjusted unless instructed by
a Muratec technical
representative.
Note: Total value of Machine
parameter 04 and 18 will be
effect for “Leading edge
document margin adjustment
Switch 76543210 Settings
10111111 - 4.0887 mm
10111110 - 4.0238 mm
 
 
10000010 - 0.1298 mm
10000001 - 0.0649 mm
00000000 0.00 mm
00000001 0.0649 mm
00000010 0.1298 mm
 
00001110 0.9086 mm
 
00111110 4.0238 mm
00111111 4.0887 mm
Initial Setting TBD