User`s guide

2.15
Setting the command in the Subject line
After receiving the command that you enter in the “Subject” line of your E-mail message, IF-300 performs one of
the following functions: Retrieving or Programming data.
You can enter two types of command in the “Subject”line.
1. To retrieve data : %get parameters#xxxx%
2. To program data : %set paramaters#xxxx%
The following is the list of available operations
* “
XXXX ” is the password for remote access.
Operation Title of E-mail
Setting One-touch dialing. %set-onetouch#xxxx%
Retrieving One-touch dialing. %get-onetouch#xxxx%
Setting Speed-dialing. %set-speed-dial#xxxx%
Retrieving Speed-dialing. %get-speed-dial#xxxx%
Setting fax relay gateway settings. %set-fax-gateway#xxxx%
Retrieving fax relay gateway settings. %get-fax-gateway#xxxx%
Setting E-mail environment settings. %set-email-settings#xxxx%
Retrieving E-mail environment settings. %get-email-settings#xxxx%
Editing already registered E-mail account. %set-account#xxxx%
Retrieving E-mail account. %get-account#xxxx%
Retrieving fax transmission journal. %get-fax-tx-log#xxxx%
Retrieving fax reception journal. %get-fax-rx-log#xxxx%
Retrieving mail transmission journal. %get-mail-tx-log#xxxx%
Retrieving mail reception journal. %get-mail-rx-log#xxxx%
Help. %get-command-help#xxxx%