User Guide
Attaching the parts
1
Attach the document
tray by inserting it
into the appropriate
holes, as shown.
2
Attach the paper hopper into the
appropriate hole, as shown. Press
gently until the hopper won’t go
in any farther.
3
Attach the document hopper by
inserting its two pegs at a
slightly upward angle into the
appropriate holes, as shown.
Plug in and power up
1
Plug one end of the telephone line
cord into the
LINE
jack on the back of
the machine. Plug the other end of
the cord into a standard telephone
wall jack, just as you would plug in a
phone.
Note: If you purchased an optional
handset, don’t confuse its curled handset cord with the uncurled tele-
phone line cord.
2
Plug the non-pronged end of the
AC
power cord
into the
AC
power cord jack on the left side of the
machine.
3
Plug the pronged end of the
AC
power cord into
a 120
VAC
electrical outlet (use a surge suppressor, as mentioned on page 1.6).
4
Use the
AC
power switch on the front of
the machine to turn it on.The markings
are international standards: I means on,
O means off.
Setting the paper size for the multipurpose tray
The multipurpose tray can hold either letter- or legal-sized paper for your machine.
All you have to do is tell the machine which size the tray is holding.
Important: If you use a different size from the size you set here, the machine
won’t print. Be sure to change this setting whenever you load a
different paper size.
1
Press /
PROGRAM
,
J
,0,4,
ENTER
. The
LCD
shows the tray’s current setting:
2
Press or /
PROGRAM
until the paper size you want to load appears.
In this example, we’ve chosen legal-sized paper.
3
Press
ENTER
to save the setting.
Adjusting the monitor speaker’s volume
To adjust the volume of the monitor speaker:
1
Press
MONITOR
/
CALL
on the control panel.You should hear a dial tone, and the
display shows:
Important: If you don’t hear a dial tone, make sure your fax machine is
plugged into a working phone line.
** Tel Mode **
_
Paper Size: Legal
Program/Enter
Paper Size: Letter
Program/Enter
Paper hopper
Document
hopper
1.8
Getting started