User Guide

2.7
Installing Muratec Software
Configuring Fax and Internet Gates
If you select Network Configuration Server option (see page 2.5),
when your computer restarts after the Muratec software has installed,
you will be prompted to configure the fax and Internet gates allowing
you to send and receive faxes and e-mails on the SmarThru system.
If you select the Stand-alone configuration or SmarThru
networking option (see page 2.5), the following wizards appear only
the first time you try to launch Mailbox in the SmarThru program. For
information on SmarThru, please refer to the SmarThru Help.
1. When the New Modem Wizard appears, choose the system modem
installed in your system and then click Next. This fax modem will be
used by SmarThru Fax Gate for sending and/or receiving faxes.
2. Click Finish to save the modem setting.
Notes:
• The Windows NT or 2000 users must click System modems... to open
install New Modem dialogue book. Follow the instructions on screen to
install fax modem on your computer.
• If there is no fax modem installed in your PC, you cannot use the PC
fax feature. Purchase an internal or external fax modem and install
into your PC and then configure the fax modem.
Note: To configure the Internet gate, you must enter your e-mail
address, incoming (POP3 or IMAP4) and outgoing (SMTP) mail server
address, and account name. Ask your Internet service provider or on-line
service provider for the information on your Internet gate configuration.
Notes: The SmarThru FAX feature is available only if there is a FAX
modem installed in your PC. Press Cancel if theere is no FAX
modem installed in your PC.